Car Door handle bumper hood Vinyl Clear Bike protective film 23" 59cm 30cm width

Description

Protective film Sticker Bikes High Quality Vinyl Clear Transparence Film Thickness 0.2mm
Wide: 60cm 30cm 20cm 15cm 10cm . Car Door handle bumper hood protective film
Brand: 3M
Product introduction
Product Name: 3M car paint protective film (commonly known as rhinoceros skin)
Material: opvc colorless transparent body (polyurethane)
Transparency: transparency
Weather resistance: more than five years
Temperature range: high temperature 120 ℃ to low temperature 75 ℃
Mainly pasted on:
1. Bicycle: whole frame covering protection, fixed circuit, etc
2. Car: 3.5-4 meters at the seam edge of the car door (to prevent the door from damaging the paint), 2 meters at the threshold, 4 meters at the bumper, and about 1 meter at the handle of the rear-view mirror. Generally, a car is about 3-10 meters.
Product specification:
Length: a roll 30 meters long
Film thickness: 0.22mm
wire ductility: 1:2
Viscosity: super strong
paste: lasting
Adhesiveness: complex surface
residual glue: None
Tensile force: 20Pa
impact resistance: 2.5kg
Thermal resistance: 75 ℃ corrosion resistance
Super elastic scratch like rhino skin protective film makes your car no longer suffer
usage method:
Check the car paint: check the car paint for scratches, corrosion marks, paint repair, paint drop, crystal plating, etc
Cleaning the car paint: the key step is to thoroughly clean the car, wash the car from coarse to fine, and ensure the car paint is clean and tidy, so as to avoid the influence of foreign matters on the construction effect
Measure the car and cut the film: before applying the film by hand, you need to measure the size of the installation position to determine the required approximate size. Next, you need to mix the installation liquid (usually detergent and shower gel mixed with water) and install the protective cover on your car.
Film sticking process: remove the bottom film - spray the installation solution evenly on the nick film and the paint surface to be pasted - attach the paint surface, scrape and drain the water, drive out the water between the film and the paint surface evenly - cut the edge, cut off the excess film edge, and leave about 5cm edge for edge wrapping.
Check the edge wrapping: use the baking gun, adjust the appropriate temperature, wrap the left edge into the inside of the paint surface, and then carefully check and deal with the details
Feedback
We will be very appreciated if you can leave us a positive feedback
after you have received the item ,
while we also hope you can contact us first
if you have anything unsatisfied with the item or service
but not just leave us a negative feedback,
so that we can solve the problem in time.
We will try our best to meet your needs
because we really want to do this job better and better.
Thank you so much for your sincere